Assemble the box and set the firmware

By the end of this page the UPS is charging, the memory and SSD are fitted, and the firmware is set so the box powers itself on and keeps its disk key in the TPM.

On this page

Set up the UPS first #

The UPS goes in first, so everything else is plugged into it from the start.

  1. Unbox the UPS and read its quick-start sheet. If it says the battery must be connected before first use, do that.
  2. Plug it straight into a wall socket, not a power board, and switch it on.
  3. Plug the box's power brick, your router and your modem into its battery-backed outlets.
  4. Connect the UPS's USB cable to the box.

It works straight away, but it needs about 8 hours to charge fully. Leave the outage test on Prove it works until then.

Two things to leave alone:

  • The UPS's network surge jacks. Run the box's Ethernet cable straight to the router; a surge jack can cap a 2.5 Gb port at 1 Gb.
  • The UPS maker's own monitoring software. NUT replaces it, and the two would fight over the USB connection.

Fit the memory and the SSD #

The reference build has a tool-free chassis with a lever for the cover. Follow the maker's quick-start diagram for the exact slot positions.

  1. Work on a hard surface, not carpet. Touch something metal first to discharge static.
  2. Turn the box over and open the cover.
  3. Memory: hold the stick at about 45 degrees, push it firmly into the first slot until the gold contacts disappear, then press it down flat until both clips lock. Leave the second slot empty for a second stick later.
  4. SSD: slide it, label up, into the first M.2 slot at a slight angle, press it flat, and secure it with the latch or screw. Leave the second M.2 slot free for another drive later.
  5. Close the cover.

First power-on #

  1. Connect the monitor, the USB keyboard, Ethernet to the router, and the power brick, which is already on the UPS.

  2. Press the power button and tap F2 repeatedly to enter the firmware setup. F10 is the boot menu. Other makers use other keys; the first screen names them.

  3. Check that the firmware shows all the memory and the SSD.

  4. Update the firmware now if the maker's support page lists a newer version. A later update can make the TPM refuse to unlock the disk until you bind it again, so it is easier to do first.

Four firmware settings #

Menu names differ slightly between makers and versions.

Setting Set to Why
After Power Failure, or Restore on AC Power Loss Power On The box restarts by itself after a power cut or a UPS shutdown.
Secure Boot Enabled The TPM unlock is tied to it.
TPM, or Intel PTT Enabled It holds the disk key.
Supervisor or administrator password Set one, and save it in 1Password It stops someone with the machine changing the boot order or turning Secure Boot off.

Save and exit, usually with F10.

You come back for one more setting after Ubuntu is installed: turning off booting from USB and the network. It has to stay on for now, because the installer boots from USB.

Next, install Ubuntu.